Last time I saw this, it was due to a missing terminator on the SCSI bus, Has this machine ever worked in this configuration (i.e with this single drive)
What type (make model) is the drive ?
On Saturday 04 May 2002 08:54, Ricardo Campos wrote:
I'm trying to install Debian on a box with a SCSI HD. Unfortunately, I'm having a few problems... I'm having probs with the HD. I get these messages when I boot from the debian rescue floppy:
(scsi0): detects card OK, then says:- scsi: <fdomain> Detection failed (no card) scsi0 <Adaptec AHA-294x Ultra2 SCSI host adapter> scsi : 1 host. (gives correct details of HD) scsi: detected 1 SCSI disk in total. sda: Spinning up disk... not responding sda: READ CAPACITY failed Partition check: sda:SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 28000002 [valid=0] Info fld=0x0, Current sd08:00: sense Key Not Ready Additional sense indicates Logical unit not ready cause not reportable scsidisk I/O error: dev 08:00, sector 0 unable to read partition table.
I have a few jumpers I have not set (i.e off), but could if needed. These are: MTR -RMT Start DLY: Start Delay SYN: Synchronous LED: LED
Any ideas?