On Sun, October 15, 2006 12:14 am, Wayne Stallwood wrote:
On Sat, 2006-10-14 at 22:45 +0100, Ted.Harding@nessie.mcc.ac.uk wrote:
In my case, there was initially only one, so that was eth0 anyway. Then I installed the second one, and this is a different model from the first (first is 3Com 3c509, second a 3c590), so this may be the hook. But what would happen if (say) they were both 3x590? It may be that it depends on the order in which they are detected on bootup which would have to do with their PCI identities, but there I'm only guessing!
I think that everything else being equal, lowest PCI bus ID wins
Actually I used to have a problem with my old Fujitsu sub notebook because depending on the link status of the ethernet socket at boot it would swap the wired and wireless interfaces.
However I think that was a special case.
We have servers from rackservers.com that break this rule, for some unknown reason eth0 and eth1 are switched. We have to modify kickstart rules only for these builds, which use almost identical hardware to others that we have.
Not very helpful, and no answer to the original question, but hey! :)
-Mark
----------------------------------------------------------- This message may contain confidential and/or privileged information. This information is intended to be read only by the individual or entity to whom it is addressed. If you are not the intended recipient, you are on notice that any review, disclosure, copying, distribution or use of the contents of this message is strictly prohibited. If you have received this message in error, please notify the sender immediately and delete or destroy any copy of this message.