I just upgraded my wireless router becuase the old one kept dropping the line now I have an ADSL MAX connection. Glad to say the new one holds up much better.
However, it connects via wireless no problem to the two Windows PCs in the network but I have had a lot of trouble connecting my Slackware laptop to it. The laptop has a Cisco Aeronet PCMCIA wireless card theat is 802.11b - one of a pair I got off an ALUG member. It has worked fine until now. I am running Slackware current. During boot the PCMCIA module finds the card as usual and sets it off. However, as soon as hotplug strarts it gets turned off again.
ifconfig does not show it but iwconfig does - presumably showing the PCMCIA setup. no amount of command line jiggerry pokery will get it going for n=anything more than a few seconds.
So I disabled hotplug during boot and sure enough the card stays on but is not connected. A quick ifconfig eth0 up followed by dhcpcd eth0 gets it going. So as a temporary measure I can place these commands in rc.local - must do that as soon as I have sent this - but what I need to know is what is hotplug doing to upset things? The strange thing is that it all worked fine with the old modem. Any ideas?
Ian